Hitachi Compute Blade 500 Series User Manual page 308
Hide thumbs
Also See for Compute Blade 500 Series:
- User manual (456 pages) ,
- Management module setup manual (362 pages) ,
- Web console users manual (240 pages)
Table of Contents
Advertisement
contact technical support for additional assistance.
The following VD is affected: X. Press any key to
continue.
Two BBUs are connected to the adapter. This is not
a supported configuration. Battery and caching
operations are disabled. Remove one BBU and
reboot to restore battery and caching operations.
If dirty cache is lost in this boot, that could have
been because of dual battery presence.
Firmware did not find valid NVDATA image.
Program valid NVDATA image and restart your
system. Press any key to continue.
IR to MR Migration failed. Press any key to
continue with MR defined NVDATA values
There are offline or missing virtual drives with
preserved cache. Check the cables and ensure that
all drives are present. Press any key to enter the
configuration utility.
Incompatible secondary iButton present! Please
insert the correct iButton and restart the system.
Press any key to continue but OEM-specific
features will not be upgraded.
Upgrade Key Missing! An upgrade key was present
on a previous power cycle, but it is not connected.
This can result in inaccessible data unless it is
addressed. Reattach the upgrade key and reboot.
FW Flash in Progress. Please Reset system after X
minutes.
Serial Boot ROM(SBR) device is corrupt or bad.
Please contact Tech Support.
4-98
Message
MegaRAID WebBIOS for storage expansion blades
Hitachi Compute Blade 500 Series EFI User's Guide
Description
Valid setting files are not found.
When this message is displayed,
contact your reseller or call
maintenance personnel.
Migration is not supported. When
this message is displayed, contact
your reseller or call maintenance
personnel.
No virtual drive is found. When this
message is displayed, contact your
reseller or call maintenance
personnel.
iButton is incorrect. When this
message is displayed, contact your
reseller or call maintenance
personnel.
Any upgrade key is not supported.
When this message is displayed,
contact your reseller or call
maintenance personnel.
Firmware is being written. Restart
the system X minutes later.
A Serial Boot ROM (SBR) is faulty.
When this message is displayed,
contact your reseller or call
maintenance personnel.
Hide quick links:
Advertisement
Table of Contents
