Hitachi Compute Blade 500 Series User Manual page 306
Hide thumbs
Also See for Compute Blade 500 Series:
- User manual (456 pages) ,
- Management module setup manual (362 pages) ,
- Web console users manual (240 pages)
Table of Contents
Advertisement
Raid Key Authentication Error. Please check the
RAID Key installed for this solution. If problems
persist contact Tech Support.
Raid Key OEM Authentication Error. Install the
correct RAID key for this System. If problems
persist contact Tech Support.
There are more enclosures connected to the port
than what is allowed for a single SAS port. Remove
the extra enclosures, and then restart your
system.
Invalid SAS topology detected. Check your cable
configurations, repair the problem, and restart
your system.
Invalid SAS Address present in SBR. Contact your
system support. Press any key to continue with the
default SAS address.
Invalid SAS Address present in MFC data. Program
the valid SAS Address, and restart your system.
Invalid memory configuration detected. Contact
your system support. System has halted.
Entering the configuration utility in this state will
result in drive configuration changes. Press Y to
continue loading the configuration utility or power
off your system and check your cables to ensure
that all the disks are present, and then restart.
External Enclosure does not support in controller's
Direct mapping mode. Contact your system
support. System has halted due to unsupported
configuration.
Expander Detected in controller with Direct
mapping mode. Reconfiguring automatically to
persistent mapping mode. Automatic reboot would
happen in 10 seconds.
The controller's I/O processor has a fault that can
potentially cause data corruption. Your controller
needs replacement. Contact your system support.
Press Y to acknowledge
Number of disks exceeded the maximum
supported count of X disks. Remove the extra
drives and reboot the system to avoid losing data
Press Y to continue with extra drives.
Number of devices exceeded the maximum limit of
devices per quad. Remove the extra drives and
reboot the system to avoid losing data. System
has halted due to unsupported configuration.
4-96
Message
MegaRAID WebBIOS for storage expansion blades
Hitachi Compute Blade 500 Series EFI User's Guide
Description
Incorrect enclosures are detected.
When this message is displayed,
contact your reseller or call
maintenance personnel.
When this message is displayed,
contact your reseller or call
maintenance personnel.
When this message is displayed,
contact your reseller or call
maintenance personnel.
When this message is displayed,
contact your reseller or call
maintenance personnel.
Hard disk configuration information
has been changed. When this
message is displayed, contact your
reseller or call maintenance
personnel.
Incorrect information was detected
from the enclosure. When this
message is displayed, contact your
reseller or call maintenance
personnel.
An unsupported device (expander)
is detected. When this message is
displayed, contact your reseller or
call maintenance personnel.
The processor of the controller is
faulty. When this message is
displayed, contact your reseller or
call maintenance personnel.
Improper hard disks are detected.
When this message is displayed,
contact your reseller or call
maintenance personnel.
Hide quick links:
Advertisement
Table of Contents
