Advanced Menu; Digital Cinema Reality; Blanking; Input Resolution - Panasonic DLP PT-D6000 Functional Instructions
Dlp based projector for commercial use
Hide thumbs
Also See for DLP PT-D6000:
- Specification sheet (2 pages) ,
- Functional instructions (52 pages)
Table of Contents
Advertisement
ADVANCED MENU
Remote control
See "Navigating through the menu" on page 15.
See "Main menu and Sub-menu" on page 12.
DIGITAL CINEMA REALITY
You can improve the vertical resolution for PAL (or SECAM)
576i, NTSC 480i, 1080/50i or 1080/60i signals. Press I H to
cycle through the options.
Detects PAL (or SECAM) 576i, 1080/50i, NTSC
AUTO
480i and 1080/60i input signals and change the
setting properly.
OFF
Deactive
Detects only PAL (or SECAM) 576i and 1080/50i
25p FIXED
signals, and adjust the vertical resolution of the
image to 2:2 pulldown.
Detects only NTSC 480i and 1080/60i signals,
30p FIXED
and adjust the vertical resolution of the image to
2:3 pulldown.
NOTE:
• 25p FIXED or 30p FIXED setting with signals that is not 2:2
pulldown may result low quality.
BLANKING
You can perform fine adjustments for blanking if noise appears
at the ends of the screen or the image protrudes out of the
screen during image projection using a VCR and so on. Press
F G to select the edge to adjust, and I H to move the inner
edge of the blank.
UPPER
LEFT
I: Moves the inner edge of the blank area to outside.
H: Moves the inner edge of the blank area to inside.
E
NGLISH - 22
LOWER
RIGHT
Setting range
Models
PT-DZ6710E/PT-DZ6700E
PT-DW6300E
PT-D6000E
INPUT RESOLUTION
Input resolution adjustment achieves the best image when the
screen flickers or halo is observed around the contour, vertical
stripes or stuck pixels appear on the screen. Press F G to
select the required option to change, and I H to change the
value. The initially displayed values vary according to the
selected input signal.
TOTAL DOTS
DISPLAY DOTS
TOTAL LINES
DISPLAY LINES
NOTE:
• The vertical stripes will not appear on the all white signal
image.
• The picture may be distorted during the adjusting operation,
but this is not a fault.
• The input resolution can be adjusted only when RGB signal
input is applied with RGB1 and RGB2 IN.
• With PT-DW6300E/PT-D6000E, automatic adjustment is not
available if signals having a dot clock frequency of more than
150 MHz are supplied.
CLAMP POSITION
When black part of the image is losing its colour or becomes
green, you can adjust to the best colour. Press I H to change
the value.
Setting range: 0 to 255
NOTE:
• Available with signals from RGB 1 IN/RGB 2 IN only.
Vertical
Horizontal
0 - 599
0 - 959
0 - 399
0 - 639
0 - 383
0 - 511
Hide quick links:
Advertisement
Table of Contents
