Table of Contents
Advertisement
Optional Parts
Connector Kits for Connection of Motor and Encoder
Used for: MUMA 50W to 400W
(1) Part No. DV0P3670
(2) Components
Name
Connector
Connector (6P)
Connector pin
Connector (4P)
Connector pin
Connector (6P)
Connector pin
<Note>
You may use parts of other manufacturer equivalent to the above parts for such components as connector, connec-
tor cover, etc.
(3) Pin arrangement of connector CN X4 plug
(4) Recommended manual
pressure bonding tool
(A customer is requested to
provide it by himself.)
<Cautions>
1. The above figure shows the pin arrangement viewed from the soldering side of the connector.
Also check pin Nos. carved on the main body of the connector so as to avoid incorrect wiring.
2. Be sure to connect shield of the shielded wire to be used to the case (FG).
3. For wiring and connection, refer to "System Configuration and Wiring", Connector CNX4 (Page 29).
Incremental
2500 pulse 5-wire
Manufacturer's part No.
Number
55100-0600
172160-1
170365-1
172159-1
170366-1
5557-06R-210
5556PBTL
1 +5V
3 +5V
5 Tx/Rx
Name
For junction of encoder cable
For junction of motor power line
For connector CN X3
Manufacturer
1
Molex Incorporated
Manufactured by
1
Tyco Electronics AMP K.K.
6
Manufactured by
1
Tyco Electronics AMP K.K.
4
1
Molex Incorporated
4
2 0V
4 0V
6 Tx/Rx
(Case FG)
Manufacturer's part No.
755330-1
Tyco Electronics AMP K.K.
755331-1
57026-5000
57027-5000
186
Remarks
For connector CN X4
(pin 6)
For junction of encoder
cable (pin 6)
For junction of motor
power line (pin 4)
For connector CN X3
(pin 6)
Manufacturer
Wire rod
UL1007
Molex Incorporated
UL1015
–
Advertisement
Table of Contents
