Table of Contents
Advertisement
Display Messages
Model 1630A/D/G
ERROR use l) or l - This message is displayed when trying to enter a non- binary character in a specification
that is set to accept only binary entries .
ERROR use 0, 1, or DON'T CARE - This message is displayed when trying to enter a non-binary character in a
specification field that is set up to accept only binary or "don't care" entries .
ERROR use 0 thru 3 - This message is displayed when trying to enter too large a value into a field made up of
only two bits, and set to accept a number base other than binary .
ERROR use 0 thru 3 or DON'T CARE - This message is displayed when trying to enter too large a value into a
field made up of only two bits, and set to accept either a DON'T CARE, or a number with a non-binary base .
ERROR use 0 thru 7 - This message is displayed when pressing an "8" or "9" key for an entry in a field that
accepts only numbers in the octal number base or is made up of only 3 bits.
ERROR use 0 thru 7 or DON'T CARE -This message is displayed when trying to entera non-octal character in
a specification field that is set up to accept only octal or "don't care" entries, or is made up of only 3 bits .
ERROR value is too large-This message is displayed when pressing a numeric key in a numeric field, but the
number is too large for the cursor position in the numeric field .
ERROR write protected file - This message is displayed when the highlighted bar is on a file that is write
protection enabled and a write operation is attempted .
ERROR 1630A/D learn string -The 1630G has been sent a learn string that was generated for a 1630A or 1630D
logic analyzer . Learn strings from other analyzers are not compatable with the 1630G.
INSERT to add compare item - This message is displayed in the state and compare list display . It indicates that
a duplicate of the line shown in inverse video can be added to the compare list by pressing the INSERT key .
INSERT to add new label - This message is displayed when the cursor is in the label field of the format
[Assignment] menu. It describes what must be done to create a new label in this menu.
INSERT to add new module - This message is displayed when creating code modules on the [Relocation]
menu of the FORMAT specification . It describes what must be done to create an additional code module in the
map .
INSERT to add new range -This message is displayed when the cursor is in the range field of a menu, and the
analyzer has space available in that field for creating additional ranges .
INSERT to add or'd pattern - This message is displayed when the cursor is in the proper position to allow entry
of an additional term to be OR'd with the present term in the specification . It describes what must be done to
create this additional term .
INSERT to add sequence term - This message is displayed when the cursor is in the proper position to allow
entry of a sequence term. It describes what must be done to create a new sequence term in this menu.
INSERT to add traces-This message is displayed in the waveform display when the cursor is in the proper area
to add more waveform channels to the display . The message indicates how to add the additional channels .
INSERT to autoscale - This message is displayed in the chart menus. Press INSERT to set the max and min
scale values to the maximum and minimum data values currently displayed .
INSERT to correlate x cursor - This message is displayed in the waveform menus of an interactive state/timing
measurement if the current trace was state triggers a don't care timing trace. Press INSERT to align (in time)
the displayed x cursor (Example : state) with the non-displayed (Example : timing) x cursor .
A-4
Hide quick links:
Advertisement
Table of Contents
