Miele AWG 102 Operating And Installation Instructions page 9

Hide thumbs Also See for AWG 102:

Table of Contents

^ Make a C 185 mm hole in the wall.

^ Push the telescopic wall pipe into the

hole so that it is sitting flush.

The telescopic wall pipe will make it

easier to feed the control cable and

the flexible ducting through later on.

^ Position the motor unit fixing bracket

on the outside wall with the control

cable connection at the bottom.

^ Mark the positions for three drill

holes.

^ Drill three 8 mm C holes and plug

with S8 plugs.

^ Connect the 3 mountings through the

fixing holes in the bracket as illustrated.

^ Position the bracket onto the outside

wall again and feed the control cable

with the six-pole connectors through

the telescopic wall pipe into the

house.

^ If equipotential bonding is required,

pull the earth cable through the hole

provided.

Equipotential bonding is required if

the control cable is to be extended

by more than the length of the

extension cable supplied (see

"Electrical connection").

Installation

Table of Contents

Show Quick Links

Table of Contents

Ablg 202 Ddf 125 Ddf 150 Ddg 102 Mg 100