Important Warnings; Getting Ready; Ironing Without Steam - Bosch TDA 46 Operating Instructions Manual
Hide thumbs
Also See for TDA 46:
- Operating instructions (2 pages) ,
- Operating instructions (2 pages) ,
- Manual (67 pages)
Table of Contents
Advertisement
Available languages
Available languages
en
Important warnings
Do not allow the power cord to come
into contact with the soleplate when it
is hot.
Store the iron in upright position.
Do not use descaling agents, they can
damage the appliance.
Never use sharp objects or abrasive
products to clean the soleplate or any
other part of the appliance.
To keep the soleplate in good
condition, do not allow it to come into
contact with metal objects. Do not use
scourers or chemical products to clean
the soleplate.
Filling the water tank
Set the steam regulator to the
position and unplug the iron
from the mains!
Use only clean water from the tap
without mixing anything with it. The
addition of other liquids, such as
perfume, will damage the appliance.
Any damage caused by the use of
the aforementioned products will
make the guarantee void.
Do not use condensation water from
tumble dryers, air conditionings or
similar. This appliance has been
designed to use normal tap water.
To prolong the optimum steam function,
mix tap water with distilled water 1:1.
If the tap water in your district is very
hard, mix tap water with distilled water
1:2.
Never fill beyond the "max" water
level mark!
Before using the iron for the
first time
Remove any label or protective
covering from the soleplate.
With the iron unplugged, fill in the tank
of the iron with tap water and set the
temperature control dial to "max"
Plug in the appliance to the mains.
When the steam iron has reached
10
the desired temperature (pilot light
switches off), start steaming by setting
the steam regulator to the maximum
steam setting and by repeatedly
pressing the button
When using the steam function for
the first time, do not apply it on the
laundry, as there could still be dirt in
the steam dispenser.
When turned on for the first time, your
new iron may smell and emit a little
smoke and a few particles; this will
stop after a few minutes.
How to use the iron
Check
the
temperature in the label on the
(1)
garment.
•
••
•••
If you don't know what kind or kinds of
fabric a garment is made of, determine
the right ironing temperature by ironing
a part that will not be visible when you
wear or use the garment.
Start ironing the garments that require
the lowest ironing temperature, such
as those made of synthetic fibres.
Silk, wool or synthetic materials: iron
the reverse side of the fabric to prevent
shiny patches.
Getting ready
Remove any labels or protective
coverings from the soleplate.
Ironing without steam
Set steam control to the
.
recommended
ironing
Synthetics
Silk-Wool
Cotton-Linen
(2)
position.
Advertisement
Table of Contents
