3. Connect the lead wires of CHARGER board (SP101) to the TP182 (dark blue), TP183 (red/dark blue). (Refer to Fig. 4)
4. Connect the lead wires of SP201 to the TP282 (natural), TP283 (red). (Refer to Fig. 4)
5. Remove the one side of resistor (22 kΩ) of TP284, and connect to TP184. (Refer to Fig. 4)
6. The screw is closes into the hole (two places) where housing (R-CH side) is fi xed. It closes it so that air should not leak. (Refer to Fig.
5)
Note: The problem is not in this hole even if it closes it with not the screw but clay, tape and so on. The hole is completely closed with stability so as not to