Operations; Unlocking, Removing, And Replacing Magazines (Operations > Unlock Left Or Right Magazine); Cleaning A Tape Drive (Operations> Clean Drive) - HP StoreEver MSL2024 User And Service Manual
Hide thumbs
Also See for StoreEver MSL2024:
- Quickspecs (26 pages) ,
- Quickspecs (25 pages) ,
- Quickspecs (30 pages)
Table of Contents
Advertisement
Operations
The Operations menu provides access to the following options:
"Unlocking, removing, and replacing magazines (Operations > Unlock Left or Right Magazine)"
(page 104)
"Cleaning a tape drive (Operations> Clean Drive)" (page 104)
"Moving tapes in the library (Operations > Move Tape)" (page 105)
"Updating tape cartridge inventory (Operations > Perform Inventory)" (page 106)
"Rebooting the library (Operations> Reboot library)" (page 106)
"Enabling password locks (Operations > Enable Library Password Locks)" (page 106)
To access the Operations menu:
1.
From the Home screen, press Previous or Next until the screen displays Operations. Press
Enter to select.
2.
Press Previous or Next until the screen displays your selected function. Press Enter to
select.
Unlocking, removing, and replacing magazines (Operations > Unlock Left or Right Magazine)
These OCP options let you gain access to the left and right magazine. Access to the magazines
requires the use of the administrator password.
To remove a magazine:
1.
From the Home screen, press Previous or Next on the OCP until the screen displays
Operations.
2.
Press Enter to select.
3.
Press Previous or Next until the screen displays either Unlock Left Magazine or Unlock
Right Magazine.
4.
Press Enter to select the desired magazine to unlock.
5.
Enter the administrator password if requested.
6.
The display reads Left Magazine Unlocked or Right Magazine Unlocked.
7.
Pull the released magazine out of the device.
8.
The screen now displays Insert Left Magazine or Insert Right Magazine. The device cannot
perform any other operation until the magazine is replaced. After exchanging tapes in a
magazine, slide the magazine completely into the device. The magazine locks into place
once it is correctly installed and the device inventories the magazine. The Ready LED blinks
while the device inventories the magazine and then stops when the operation is complete.
Cleaning a tape drive (Operations> Clean Drive)
When the Clean LED is on, a tape drive needs to be cleaned. Cleaning times can range from a
few seconds to a few minutes during which time the Ready LED blinks. Use only the designated
cleaning cartridge for your tape drive model. All cartridges are available at
info/storagemedia.
Use only Ultrium Universal cleaning cartridges.
IMPORTANT:
Invalid Tape and the cartridge is returned to its original location.
IMPORTANT:
the same cartridge after you have cleaned the drive, there might be a problem with that cartridge.
If you use the OCP to clean the tape drive, load the cleaning cartridge into the mailslot or any
other empty slot before beginning the cleaning steps. If you would like to keep a cleaning cartridge
104 Operating the tape library
If the cleaning cartridge is not a valid cleaning cartridge, the LCD screen displays
If the Clean LED or the Attention LED (on load or unload) lights when inserting
http://www.hpe.com/
Advertisement
Table of Contents
