3A-1 Drive Shaft / Axle: Front
Drive Shaft / Axle
Driveline / Axle
Front
Front Drive Shaft Construction
A constant velocity ball joint is used on the wheel side of both right and left side drive shaft assemblies. A tripod type
constant velocity joint is used on the differential side and center shaft side. The drive shaft can slide through the tripod
joint in the extension/contraction direction.
Front Drive Shaft Assembly Components Location
1. To transaxle
2. Drive shaft assembly
3. Tie-rod end
4. Tie-rod end nut
5. Ball stud bolt
6. Drive shaft nut
: After tightening nut to specified torque,
caulk nut securely.
General Description
Component Location
7. Wheel nut
8. Center shaft assembly (if equipped)
9. Center bearing support bolts (if equipped)
10. Washer
: 45 N⋅m (4.5 kgf-m, 32.5 lb-ft)
: 60 N⋅m (6.0 kgf-m, 43.5 lb-ft)
S6RW0C3111001
S6RW0C3113001
I6RW0C311001-01
: 200 N⋅m (20.0 kgf-m, 145.0 lb-ft)
: 85 N⋅m (8.5 kgf-m, 61.5 lb-ft)
: 55 N⋅m (5.5 kgf-m, 40.0 lb-ft)
: Do not reuse.