Table of Contents
Advertisement
DTC Detecting Condition and Trouble Area
DTC detecting condition
DTC P0532:
Output voltage of A/C refrigerant pressure sensor is lower than 0.2
V for 5 sec.
(1 driving cycle detection logic but MIL does not light up)
DTC P0533:
Output voltage of A/C refrigerant pressure sensor is higher than
4.93 V for 5 sec.
(1 driving cycle detection logic but MIL does not light up)
DTC Confirmation Procedure
1) With ignition switch turned OFF, connect scan tool.
2) Turn ON ignition switch and clear DTC by using scan tool.
3) Check DTC.
DTC Troubleshooting
Step
1
Was "Engine and Emission Control System Check"
performed?
2
A/C refrigerant pressure sensor and its circuit check
1) Check A/C refrigerant pressure sensor and its circuit for
condition referring to "A/C Refrigerant Pressure Sensor
and Its Circuit Inspection in Section 7B".
Is it in good condition?
DTC P0601 / P0602 / P0607: Internal Control Module Memory Check Sum Error / Control Module
Programming Error / Control Module Performance
System Description
Internal control module is installed in ECM.
DTC Detecting Condition and Trouble Area
NOTE
After reprogramming of ECM is executed, if the DTC P0601 and/or P0602 are indicated, it is possible
that the reprogramming of ECM is not completed correctly.
DTC detecting condition
DTC P0601:
Data write error or check sum error.
(1 driving cycle detection logic, monitoring once per driving cycle)
DTC P0602:
Data programming error.
(1 driving cycle detection logic but MIL does not light up)
DTC P0607:
ECM internal processor error.
(1 driving cycle detection logic)
DTC Confirmation Procedure
1) With ignition switch OFF, connect scan tool.
2) Turn ON ignition switch and clear DTC by using scan tool.
3) Start engine and run it at idle if possible.
4) Check DTC.
Action
Engine General Information and Diagnosis:
Trouble area
• A/C refrigerant pressure sensor and/or its
circuit
• ECM
Yes
Go to Step 2.
Substitute a known-
good ECM and recheck.
• ECM power supply circuit and or ground
circuit
• ECM
1A-107
No
Go to "Engine and
Emission Control
System Check".
Repair or replace
defective parts.
S6RW0C1104054
Trouble area
Advertisement
Chapters
Table of Contents
Troubleshooting
