Show Host-Parameters - HP P2000 G3 Cli Reference Manual
Msa system
Hide thumbs
Also See for P2000 G3:
- Reference manual (148 pages) ,
- User manual (76 pages) ,
- Specification (43 pages)
Table of Contents
Advertisement
show host-parameters
Description Shows information about host ports on both controllers. This command shows the same information
as the
show ports
Syntax
show host-parameters
Output Ports
Controller ID and port number.
Media
•
FC(L): Fibre Channel-Arbitrated Loop (public or private).
•
FC(P): Fibre Channel Point-to-Point.
•
FC(-): Fibre Channel disconnected.
•
SAS: Serial Attached SCSI.
•
iSCSI: Internet SCSI.
Target ID
Port WWN or IQN.
Status
•
Up: Port is cabled and has an I/O link.
•
Disconnected: Either no I/O link is detected or the port is not cabled.
Speed (A)
Actual link speed in Gbit/sec. Blank if not applicable.
Speed (C)
Configured host-port link speed:
•
FC: Auto, 8Gb, 4Gb, or 2Gb (Gbit/sec).
•
iSCSI: Auto or 1Gb (Gbit/sec).
•
Blank if not applicable.
Health
•
OK
•
Degraded
•
Fault
•
N/A
Health Reason
If Health is not OK, this field shows the reason for the health state.
Health Recommendation
If Health is not OK, this field shows recommended actions to take to resolve the health issue.
Topo (C)
FC and SAS only. Configured topology.
Width
SAS only. Number of PHY lanes in the SAS port.
PID
FC only. Primary loop ID, or blank if not applicable.
IP-Ver
iSCSI only. IP version: IPv4 or IPv6.
PIP
iSCSI only. Primary IP address.
240 Alphabetical list of commands
command.
- Quick Links:
- Accessing the Cli
Hide quick links:
Advertisement
Table of Contents
