Advertisement
Setup Flow
The setup flow is shown below. For the details of each procedure, refer to the page shown.
[A] LDAP server confirmation
Worker
Service technician
Operation
Confirms the user if the attribute name used for card authentication (authentication ID) on the
LDAP server is correct. The confirmed attribute name should be set on this equipment in proce-
dure [K].
[B] Authentication method confirmation
Worker
User
Operation
Confirms if "Enable" of "Department Code" and "User Authentication" is selected. The user also
confirms if either of "Windows Domain Authentication" or "LDAP Authentication" of "Method" is
selected.
[C] Hardware installation
Worker
Service technician
Operation
Installs the e-BRIDGE ID Gate to the equipment.
[D] System setting (08-1772)
Worker
Service technician
Operation
Performs system settings to make the e-BRIDGE ID Gate features usable on the equipment.
[E] LDAP server setting (08-1927)
Worker
Service technician
Operation
Sets the attribute name of the LDAP server authentication ID which has been confirmed in pro-
cedure [A] on the equipment.
[F] Card authentication setting
Worker
User
Operation
Selects "Enable" of "Card Authentication".
KP-2004
INSTALLATION AND SETTINGS OF e-BRIDGE ID GATE
P. 2-3 "[A] LDAP server confirmation"
P. 2-3 "[B] Authentication method confirmation"
P. 2-3 "[C] Hardware installation"
P. 2-3 "[D] System setting (08-1772)"
P. 2-4 "[E] LDAP server setting (08-1927)"
P. 2-4 "[F] Card authentication setting"
Start operation
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
2 - 2
Advertisement
