Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Asus Book Size Barebone System Prodigy
Summary of Contents for Asus Book Size Barebone System Prodigy
- Page 1 Prodigy ® Book Size Barebone System User’s Guide...
-
Page 2: Disclaimer/Copyrights
Product warranty or service will not be extended if: (1) the product is repaired, modified or altered, unless such repair, modification of alteration is authorized in writing by ASUS; or (2) the serial number of the product is defaced or missing. -
Page 3: Asus Contact Information
Desktop/Server (Tel): +886-2-2890-7123 (English) Support Fax: +886-2-2890-7698 Support Email: tsd@asus.com.tw Web Site: www.asus.com.tw Newsgroup: cscnews.asus.com.tw ASUS COMPUTER INTERNATIONAL (America) Address: 6737 Mowry Avenue, Mowry Business Center, Building 2, Newark, CA 94560, USA General Fax: +1-510-608-4555 General Email: tmd1@asus.com Technical Support... -
Page 4: Notices
Notices Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. -
Page 5: Table Of Contents
Table of contents Disclaimer/Copyrights ... 2 ASUS contact information ... 3 Notices ... 4 Table of Contents ... 5 System package contents ... 6 About this guide ... 7 Chapter 1: System Introduction ... 9 1.1 Front panel features ... 10 1.2 Rear panel features ... -
Page 6: System Package Contents
If assembling the Prodigy system by yourself, read through the guide and prepare all the components before starting. NOTE: The ASUS Prodigy is shipped in barebone style: it does not include a CPU, a hard disk drive, DRAM, or any other peripherals except those listed above. -
Page 7: About This Guide
About this guide Audience This guide provides general information and installation instructions about the ASUS Prodigy Book Size Barebone System. This guide is intended for experienced users and integrators with hardware knowledge of personal computers. How this guide is organized... -
Page 9: Chapter 1: System Introduction
Chapter 1 All about the ASUS Prodigy Book Size Barebone System: the front and rear panel features, and the internal layout and design. ASUS Prodigy Book Size Barebone System... -
Page 10: Front Panel Features
Front Panel Features The ASUS Prodigy Book Size Barebone System includes the ASUS motherboard, a power supply, a CD-ROM or DVD drive and a floppy disk drive built into in a dual-positional chassis. The front panel features: USB Ports (2&3) -
Page 11: Rear Panel Features
Rear Panel Features The rear panel of the ASUS Prodigy Book Size Barebone System includes the standard PC99 I/O connectors for external devices, power supply socket, and optional feature connectors. The rear panel features: PS/2 Keyboard USB (0&1) Serial Port... -
Page 12: Internal Features
Internal Features The figure below shows the system from above. The standard components are already installed. ASUS Motherboard CPU Cooler CD / DVD ROM Drive Power Supply PCI Riser Card 3.5” Floppy Drive Chapter 1: System Introduction... -
Page 13: Chapter 2: System Assembly
Step-by-step instructions on how to install basic components. IMPORTANT: ASUS has designed the Prodigy to accept an ASUS “Flex ATX” motherboard with dimensions between 19.1 x 22.9 cm, (or 7.5 x 9 inches). It is not advisable to install other boards. -
Page 14: Opening The Chassis
Opening the chassis Remove the two screws on each end of the back panel. This frees the the top cover from the chassis. Seperate the case and top cover: use your thumbs to pull it off, from the front to the back, then lift it off the chassis. - Page 15 Prodigy Book Size Barebone System Lift the link-up bar to gain access to the components. Gently detach the three front bezel hooks from the case front so that it may be removed. Remove the front bezel and set it aside.
-
Page 16: Remove The Disk Drive Assembly
2.2 Remove the disk drive assembly Press your right thumb firmly down on the right edge of the chassis while gripping your fingers under both sides of the CD and floppy disk drive assembly. It will come loose. Firmly lift the assembly up and out. -
Page 17: Install The Hard Disk Drive
2.3 Install the hard disk drive IDE Cable Power Cable (P3) (Red strip to Pin 1) Prodigy Book Size Barebone System Carefully slip the hard disk drive into the cage. Ensure that the four screw holes are properly aligned. Tighten in the screws. -
Page 18: Install System Memory
2.4 Install system memory Set the CD and floppy disk drive assemply on the side of the chassis. Locate the two DDR SDRAM DIMM sockets on the ASUS motherboard. 184-Pin DDR DIMM Sockets CAUTION A DDR DIMM is keyed with a notch so that it fits in only one direction. -
Page 19: Install A Cpu
2.5 Install a CPU Metal retaining clip Prodigy Book Size Barebone System To install the CPU, it is necessary to remove the pre-installed heatsink assembly. Press down and unhook the metal retaining clips on both sides of the metal heatsink. Disconnect the CPU fan power cable if it is too short. - Page 20 Socket Lever 9. When the CPU is in place, press it firmly on the socket while you push down the socket lever to secure the CPU. The lever clicks on the side tab to indicate that it is locked. 6. Unlock the socket by pressing the socket lever sideways, then lift it up to a 90°-100°...
-
Page 21: Closing The Chassis
2.6 Closing the chassis Prodigy Book Size Barebone System Replace the heatsink assembly. Ensure that the black fan faces towards the front of the unit. Re-attach the CPU fan power cable. Re-attach the metal retaining clips: hook on one side then press the spring retainer down on the other until it clicks into the slot. - Page 22 Lower the link-up bar and snap it gently into place. Replace the top cover. To make sure the inner tabs slide into place properly, lay the cover down flush on top of the chassis about one centimeter behind the edge of the front bezel. Then, slide the cover forward while pressing in on the lower edges of...
-
Page 23: Chapter 3: Optional Procedures
Chapter 3 How to install optional components. Prodigy Book Size Barebone System... -
Page 24: Removing The Pci I/O Cover
Removing the PCI I/O cover The Prodigy chassis accommodates two PCI expansion card through a PCI riser card. Before installing a new PCI card, it is necessary to detach the I/O cover. To remove the I/O cover from the chassis, unfasten the screw with a Philips (cross) screwdriver. -
Page 25: Installing A Pci Expansion Card
3.2 Installing a PCI expansion card Prodigy Book Size Barebone System A PCI card is precisely sized for for easy alignment with both the onboard notches and the external I/O port. Align and firmly plug the PCI card into the slot. For card stability, make sure that the card bracket end goes into... - Page 26 Chapter 3: Optional Procedures...
-
Page 27: Chapter 4: System Placement
Chapter 4 Two system placement options help to maximize work space and afford more convenience. Prodigy Book Size Barebone System... -
Page 28: Vertical Placement
Normally, the Prodigy Book Size Barebone System is placed upright on the desk. If you desire to position the system this way, fit the two foot stands on the bottom of the system chassis. A “Powered by ASUS” nameplate is supplied, too. -
Page 29: Horizontal Placement
4.2 Horizontal placement The Prodigy may also be set-up in a horizontal position. The Prodigy is supplied with four rubber footpads to protect the chassis and the surface below. Prodigy Book Size Barebone System If you wish to place the system in the horizontal position, attach the four rubber footpads to the bottom of the chassis. - Page 30 Chapter 4: System Placement...