Chapter 5
5.3.2.14 Adjusting the Saddle Lead Edge
Stopper Position
Go through the following steps if the saddle folding
position has become displaced.
1) Generate a print using the saddle assembly, and
measure the displacement (C) of the folding
position.
[C]
F-5-108
2) Slide out the saddle assembly; then, remove the 6
screws [1], and detach the PCB cover [2].
[1]
F-5-109
3) Loosen the fixing screw [1] of the lead edge
stopper, and change the position of the stopper to
suit the displacement (C) of the following
position measured in the foregoing step. (A single
index will cause a change of 1 mm.)
Specifically, insert a Phillips screwdriver into the
adjusting hole, and move the screwdriver up/
down to move to a different index.
5-36
0015-2242
5.3.2.15 Adjusting the Saddle Alignment
Make the following adjustments if the saddle
reference is displaced.
1) Turn on the finisher.
2) Turn on the copier's power switch, and see that it
3) Open the front door, and insert the door switch
[1]
[2]
[3]
F-5-110
Reference
is in a standby state.
actuator into the door switch [1].
F-5-111
[1]
[2]
0015-2243
[1]