Table of Contents
Advertisement
Chapter 4
4) Shift the handling tray aligning plate (front) [1] in
the direction of the arrow, and remove the screw
[2] and the claw [3]; then, detach the handling
tray aligning plate (front).
[3]
F-4-36
5) Remove the handling tray (front) [1].
- 2 screws [2]
[1]
F-4-37
6) Loosen the screw [1], and free the belt [2] from the
gear [3].
[3]
F-4-38
7) Remove the aligning motor (front) [1].
(page 5-12)Reference[Adjusting the Angle of
the Aligning Plate (orthogonal)]
(page 5-15)Reference[Adjusting the Aligning
4-10
[1]
[2]
[2]
[2]
[1]
Plate Width]
- 2 clamps [2]
- 1 connector [3]
- 2 screws [4]
[2]
[1]
F-4-39
4.3.4 Rear Alignment Motor
4.3.4.1 Before Removing the Alignment
Motor (rear)
1) Remove the stacking wall (upper). (page 4-
5)Reference[Removing
(upper)]
2) Remove the stacking wall (lower). (page 4-
5)Reference[Removing
(lower)]
3) Remove the handling tray unit. (page 4-
23)Reference[Removing the Handling Tray
Unit]
[3]
[4]
the
Stacking
the
Stacking
0015-2302
Wall
Wall
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
