Ensure that all corners of the drawer
housing unit are aligned at right an‐
gles.
Push the drawer into the housing unit
as far as the vapour strip and make
sure it is correctly aligned in the unit.
Open the drawer, and use the 2
screws supplied to secure it to the
side walls of the housing unit.
Build in the combination appliance in
accordance with the operating and
installation instructions supplied with
it.
Aligning the front of the drawer
After building in the combination appli‐
ance, it may be necessary under certain
circumstances to align the front of the
drawer and adjust the gap between the
drawer and the combination appliance.
To help you do this, there are washers
underneath the nuts which secure the
drawer to the telescopic runners.
Loosen the nuts and take the drawer
out.
Use these washers to adjust the
alignment and the gap
– by fitting them above or underneath
the drawer,
– or on the sides.
Installation
23