Fujitsu ETERNUS DX80 S2 Cli User's Manual page 701
Disk storage systems
Hide thumbs
Also See for ETERNUS DX80 S2:
- User manual (186 pages) ,
- User's manual & installation instructions (147 pages) ,
- Overview (97 pages)
Table of Contents
Advertisement
Appendix A Error Messages
Message
number
E5207
E5208
E5209
E5210
E5211
E5212
E5213
E5214
E5501
E5701
E6000
E6001
E6002
E6003
E6004
E6005
E6006
E6007
E6008
E6009
Exist volume(s) of protection from copy destination.
Copy destination volumes with protection settings exist.
Copy license information updating due to trial license expired.
The copy license information is being updated. Wait for a while and try again.
Not support E6K to target of REC.
Consistency sessions are not supported for remote storage systems.
Data in disk buffer.
Data exists in the disk buffer. Check the disk buffer by using the "show rec-buffer" command.
The raid group is for REC disk buffer.
The specified RAID group is configured with an REC disk buffer. Check the RAID group by using the "show
rec-disk-buffer" command.
Source and destination RA type is not match.
The RA type does not match for the copy source and copy destination devices in the REC path settings.
Check the contents of the settings for the path file.
The times registering trial license has been reached the system limit.
The limit for the number of times that the trial license can be registered has been reached.
Exist RA.
The RA is set. Check the RA by using the "show host-port-mode" command.
iSNS server cannot be connected from the specified iSCSI CA port.
The iSNS server is not set for the specified iSCSI CA port.
The factory setup is not done.
The factory settings have not been performed.
Advanced Copy session that covers the entire volume is active.
An Advanced Copy session that affects the entire volume is being performed.
The specified volume is ODX Buffer Volume.
The specified volume is an ODX Buffer volume.
The specified volume is volume during Zero Reclamation execution.
The specified volume is a volume that is currently undergoing Zero Reclamation.
Offloaded Data Transfer Mode is valid.
The Offloaded Data Transfer mode is enabled.
Offloaded Data Transfer Mode is not valid.
The Offloaded Data Transfer mode is disabled.
ODX Buffer Volume exist.
ODX Buffer volumes exist.
The specified volume is not ODX Buffer Volume.
The specified volume is not an ODX Buffer volume.
Offloaded Data Transfer in process.
An Offloaded Data Transfer is in progress.
The specified volume is not volume during Zero Reclamation execution.
The specified volume is a volume that is currently not undergoing Zero Reclamation.
Not available under operating Bind-in-Cache.
The specified command cannot be executed because Bind-in-Cache is set.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
Message
Countermeasure for the error
701
P2X0-1030-09ENZ0
- Quick Links:
- Accessing Cli
Hide quick links:
Advertisement
Table of Contents
