Installation Preparation; Electrical Requirements - GE PSB9100DF Installation Instructions Manual
Advantium 120v
built-in speedcook
ovens
Hide thumbs
Also See for PSB9100DF:
- Installation instructions manual (19 pages) ,
- Dimension manual (2 pages) ,
- Installation instructions manual (16 pages)
Table of Contents
Advertisement
Available languages
Available languages
Installation Preparation
ELECTRICAL REQUIREMENTS
Single
Advantium
120 Installation:
This product requires a 120-volt, 60 Hz, 1S-amp
circuit and draws 1.8 kilowatts. This product must be
connected
to a supply circuit of the proper voltage
and frequency.
• Wire size must conform
to the requirements
of the
National Electrical Code or the prevailing
local code
for this kilowatt
rating.
• The power supply cord and plug should be brought
to a separate
15- or 20-ampere
branch circuit single
grounded
receptacle.
The outlet box should be
located within reach of the 48" power cord.
ELECTRICAL LOCATION
--6"
t
9"
Locate outlet box in the shaded area
Install a recessed electrical
outlet in the back wall
of the opening within 6" of either side and at least
9" above the cutout floor.
GROUNDING INSTRUCTIONS
This appliance
must be grounded.
In the event of
on electrical
short circuit, grounding
reduces the
risk of electric shock by providing
on escape wire
for electric current.
This appliance
is equipped with
a cord having a grounding
wire with a grounding
plug. The plug must be plugged into an outlet that is
properly installed and grounded.
_WARNING:
Improper
use of the grounding
plug can result in a risk of electric shock.
AiADVERTENCIA!:
El usa inadecuado
del
enchufe
de conexi6n a tierra
puede provocar
un
riesgo de descarga
el_ctrica.
Important:
IPlease
read carefully}.
The power cord of this appliance
is equipped with
a three-prong
(grounding)
plug that mutes with a
standard three-prong
grounding
wall receptacle
to
minimize the possibility of electric shock. Consult a
qualified electrician
or serviceman
if the grounding
instructions
are not completely
understood,
or if
doubt exists as to whether
the appliance
is properly
grounded.
• Where a standard two-prong wall receptacle is
encountered, it is the personal responsibility and
obligation of the consumer to have it replaced with a
properly grounded three-prong wall receptacle.
Do not, under any circumstances, cut or remove the
third (ground) prong from the power cord.
DO NOT USE AN EXTENSION CORD. If the power
supply cord is too short, have a qualified electrician
or
serviceman
install an outlet near the appliance.
Advertisement
Chapters
Table of Contents
