Dell OptiPlex 3020M Owner's Manual page 39

Hide thumbs Also See for OptiPlex 3020M:
Table of Contents

Advertisement

Option
Advance Boot Options
Date/Time
Table 3. System Configuration
Option
Integrated NIC
Serial Port
SATA Operation
Drives
SMART Reporting
USB Configuration
Description
Enable Legacy Option ROMs - This option is required for legacy boot
mode. This option is not allowed if Secure Boot is enabled.
Allows you to set the date and time. The changes to the system date and
time takes effect immediately.
Description
Allows you to enable or disable the integrated network card. You can set
the integrated NIC to:
Enable UEFI Network Stack (disable by default)
Disabled
Enabled
Enabled w/PXE- This option is enabled by default.
Enabled w/Cloud Desktop
NOTE: Depending on the computer and the devices installed, the
items listed in this section may or may not appear.
Identifies and defines the serial port settings. This option appear only if
your system installed serial port card. You can set the serial port to:
Disabled
COM1 (Default)
COM2
COM3
COM4
NOTE: The operating system may allocate resources even if the
setting is disabled.
Allows you to configure the operating mode of the integrated hard drive
controller.
Disabled - The SATA controllers are hidden.
ATA - SATA is configured for ATA mode.
AHCI - SATA is configured for AHCI mode. This option is enabled by
default.
Allows you to enable or disable the on-board drive:
SATA-0
This field controls if the hard drive errors for the integrated drives are
reported during system startup. This technology is part of the SMART (Self
Monitoring Analysis and Reporting Technology) specification.
Enable SMART Reporting - This option is disabled by default.
This field configures the integrated USB controller. If Boot Support is
enabled, the system is allowed to boot any type of USB mass storage
devices (HDD, memory key, floppy).
39

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents