Step 3 Install Insert Sleeve - GE ZVC30LSS Installation Instructions Manual

Hide thumbs Also See for ZVC30LSS:

Table of Contents

STEP 3 INSTALL INSERT SLEEVE

1. Tuck the house wiring out of the way.

2. Install the insert sleeve into the cutout opening of

custom cabinet frame.

Clip

3. Push the insert sleeve straight up through the

cutout opening until the temporary locking clips

engage. The locking clips are designed to hold the

insert sleeve in place until it is secured with screws.

NOTE: The locking clips are not designed to support

all of the weight of the insert sleeve. Do not leave the

insert sleeve unattended until screws have been

inserted.

Installation Instructions

4. Align 8" duct to exhaust opening of insert sleeve

and seal with aluminum tape.

NOTE: House duct should drop to 11-1/2" above

bottom edge of insert sleeve or the bottom of the

3/4" cabinet base.

5. Tape the 4 washers in place over the outside

of the 4 front and back holes of the insert sleeve.

The washers are designed to be located between

the insert sleeve and the 3/4" cabinet surface.

6. Press the sleeve up firmly and secure with the

8 screws provided. The insert sleeve should be

flush with the liner and have no visible gaps.

NOTE: It is IMPORTANT to install front mounting

screw. The front screw hole is difficult to see and

may require you to place your head into the cutout

opening to locate.

Aluminum

tape

Table of Contents

Zvc36lss Zvc48lss