Table of Contents
Advertisement
WARNING
ELECTROCUTION HAZARD
•
Never attempt to repair or perform maintenance on the appliance until the
main electrical power has been disconnected. Turning the appliance control
"OFF" does not remove electrical power from the units wiring.
•
Replace all parts and panels before operating.
Remove Drawers from unit
Begin by pulling out the top drawer. (See
Figure 9). Remove screws securing drawer
to slides (See Figure 10). Pull drawer
forward, lift up and out to clear clips in rear of
drawer. Move drawer forward about 1" (2.5
cm) and set down on slides. At the right rear
corner of the drawer disconnect the display
wire harness (See Figure 9a). Remove
the drawer from the unit by lifting up off of
the slides. Repeat for bottom drawer but
disregard the harness instructions as there is
no wiring to the bottom drawer.
To replace the air filter:
Fully extend the bottom drawer. The air filter is located on the left lower wall of the cabinet.
Remove the old air filter and replace with a new air filter. See Figure 11.
Filter
housing
Air Filter
Removing the Drawer
Remove screws
Clips
Figure 9a
Figure 10
Gasket
Figure 9
Press and hold
down this tab on
the wire connector
and pull the
connector apart.
Figure 11
13
- Quick Links:
- Alarms
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
