Mounting The Ap On A Wall - HP 425 Installation Manual
Wireless dual radio 802.11n access point
Hide thumbs
Also See for 425:
- Datasheet (12 pages) ,
- Maintenance and service manual (168 pages) ,
- Getting started (19 pages)
Table of Contents
Advertisement
2.
Place the AP on the table with the rubber feet facing down as shown in
Figure 3 Mounting the AP on the table
Mounting the AP on a wall
IMPORTANT:
Connect the AP to the network by using an Ethernet cable, and then install the AP to the wall-mounting
bracket.
To mount the AP on a wall, use the wall-mounting bracket and wall anchor kit that is supplied with the AP
as shown in
Figure 4 Screw hole locations and sizes (in mm)
1
2
(1) Hook
(3) Clip
To mount the AP on a wall:
1.
Use the wall-mounting bracket as a template to mark the locations of the mounting holes on the
bracket. Drill three 5 mm (0.2 in) diameter holes on the marked mounting hole locations as shown
in
Figure
Figure
4.
3
Ø5.0
4
86.0
136.0
5.
(2) Mounting hole
(4) Mounting clip
5
Figure
3.
Hide quick links:
Advertisement
Table of Contents
