Installation; Configuring Po'~Er; Setting The Line Voltage Select Switch; Fuses - HP 9122D Service Manual

Hide thumbs Also See for 9122D:

Table of Contents

ICHAPTER

Installa tion

121

Configuring Power

Setting The Line Voltage Select Switch

The voltage select switch on the rear panel must be set to the nominal line voltage for the area in _which it

is operating. Figure 2-1 shows the setting for the voltage select switch for the various voltages.

[g]@

11SV

Figure 2-1. Line Voltage Select Switch

Fuses

The part numbers of the fuses used for the two voltage ranges of 90-125 and 180-250 VAC are

2110-0001 and 2110-0012 respectively.

Power Cords

'~.A~f(~~~5

- '

. .

Always disconnect the disc drive from any AC line before

changing fuses.

The power cord supplied by HP has polarities matched to the power sockets on the equipment. See Figure

2 for details on the power cords.

2-1

Table of Contents

Troubleshooting

9122s