Table of Contents
Advertisement
Turning On Part of the System (Part On)
I have this feature.
I do not have this feature.
Part On turns on only a part of your system, leaving the rest of the
system turned off. Refer to the Point Identification section of your
keypad's reference card to identify Part points. Once you've pressed [0],
exit delay time starts to count down. You should leave before exit delay
time expires. Leaving after exit delay expires causes an alarm event. Use
Part On when you want part of your system turned on.
1.
Make sure Part points are normal (not faulted).
2.
Press [0]. If all Part points are normal, exit delay time begins. If
your system has faulted points, you should return them to
normal, or refer to Bypass Points.
30 SEC TO EXIT!
During exit delay, you may stop the system from turning on by
pressing [CLEAR]:
TO STOP
PRESS [CLEAR]
If you wish to, you can turn the system Part On with No Delay
by pressing [0] again:
FOR NO DELAY
PRESS 0
If you wish to, you may bypass points by pressing [
system prompts you through the procedure:
TO BYPASS POINTS
PRESS
3.
When exit delay time expires, the keypad beeps three times and
then the system turns on.
PART ON
SYSTEM OK
4.
To turn the system off, enter your personal passcode.
]. The
13
Hide quick links:
Advertisement
Table of Contents
