If Problems Occur During Monitoring - Sony DWR-R02D User Manual
Wireless studio
Hide thumbs
Also See for DWR-R02D:
- Brochure (2 pages) ,
- Operating instructions manual (45 pages) ,
- User manual (59 pages)
Table of Contents
Advertisement
The following methods are available for selecting receiver
channels.
• When you click a single receiver channel, that receiver
channel is selected.
• When you click a receiver, the two receiver channels that
are built into that receiver are selected.
• When you click and drag on the background area, all of
the receiver channels within the dragged area are
selected.
• When you click receiver channels while holding down
the Shift key or Ctrl key, all of the clicked receiver
channels are selected.
To set devices to be excluded from automatic detection
Use the Omit IP address list window (see page 34).
12
Basic Operations
If Problems Occur during Monitoring
See the following table to remedy the problem.
Problem
Cause
The receiver is
The host name or IP
not recognized.
address is already
assigned to another
device.
It takes long
If the network has a PC
until the
that is connected to a
receiver is
broadband router or the
recognized.
Internet, it may take
several minutes to
recognize the receiver.
In the dialog
If your PC is equipped
box indicating
with or connected to a
the receiver
modem or ISDN router,
detection
the Wireless Studio
results, an
software may not
abnormal value
function properly when
appears in the
you start it up when
IP address
either of the conditions
field.
described below exist.
This is because the PC
will attempt to detect
device through the
modem or router.
• The receiver is turned
off.
• The LAN cable is
disconnected.
The receiver is
The Windows firewall or
not detected
your security software's
automatically.
firewall may prevent
devices from being
detected automatically.
The "Wireless
Wireless Studio Ver. 3.0
Studio
or later supports Ver.
detected
1.20 or later of the
version
DWR-R01D firmware.
unmatch with
DWR-R01D.
Please update
the firmware of
DWR-R01D to
ver.1.20 or
later" message
appears, and
monitoring is
disabled.
Remedy
Check the host
name or IP
address settings.
Construct a
separate
network apart
from the one
containing the
PC with the
broadband
router or the
Internet
connection.
Turn on the
receiver and
make sure the
LAN cable is
connected.
Disable the
firewall settings
on the computer.
Update the
firmware of the
receivers. For
details, contact
your Sony
dealer.
Advertisement
Table of Contents
