Table of Contents
Advertisement
THROTTLE BODY AND FUEL INJECTOR
a
4. Tighten:
1
NOTE:
2
• Tighten the bolt on the left side of the scooter
• Use the pivot shaft wrench 1 and pivot shaft
• When tightening the sub-frame adjusting
5. Tighten:
NOTE:
Tighten the nut on the left side of the scooter
first.
INSTALLING THE FUEL HOSE
1. Install:
Be sure to connect the fuel hose securely
and install the fuel hose connector cover in
the correct position, otherwise the fuel
hose will not be properly installed.
NOTE:
• Install the fuel hose connector securely onto
1
• After installing the fuel hose connector cover
7 - 33
• sub-frame adjusting bolts
4 Nm (0.4 m · kg, 2.9 ft · lb)
first.
wrench adapter 2 to tighten the sub-frame
adjusting bolts.
bolts, make sure that the gap a shown
between the frame and the sub-frame is the
same on both sides of the scooter.
Pivot shaft wrench
90890-01471, YM-01471
Pivot shaft wrench adapter
90890-01476
• sub-frame front upper mounting nuts
54 Nm (5.4 m · kg, 39 ft · lb)
• fuel hose
• fuel hose connector cover
CAUTION:
the fuel tank until a distinct "click" is heard,
and then make sure that it does not come
loose.
1, make sure that it is installed securely.
FI
Advertisement
Chapters
Table of Contents
Troubleshooting
