GETTING STARTED:
M945 Super ACE III Computerised Sewing Machine
To help you get started, please follow these simple instructions in the order shown below.
However, before you do so, read the safety instructions in the Instruction Manual.
Step 1
Figure 1a
Foot
Controller
Mains Plug
• Tilt the lid of the accessory compartment up and towards you to open it.
• Inside are various accessories including a number of bobbins.
• More accessories, including two spool caps, can be found inside the accessory pouch packed with the machine.
Step 2
• The machine can be operated either by the start/stop
button or by the foot controller.
If you intend to use the foot controller, plug it in as
shown in
figure 1a
• Plug in the mains connector at the right hand side of
the machine, as shown in
mains plug into a wall socket.
Set the tension dial to 4.
• Set the stitch width lever to minimum and the stitch
length lever to midway (
• Set the sewing speed controller to midway (
Unpack the sewing machine, and familiarise yourself with all the parts and
controls that are mentioned in these instructions.
Thread Guide
Take-up
Lever
Guide
Power
Switch
Needle
Threader
Lever
Thread
Cutter
Presser Foot and
Needle Assembly
Bobbin
Cover
Prepare the sewing machine for use.
and place it on the floor.
figure 1a
. Connect the
figure 2a
).
Figure 1b
Tension
Dial
figure 2a
).
figure 2b
Spool Pin
Bobbin
Winder Shaft
Accessory Compartment
(bobbins inside)
figure 2b
XC5406051
Stitch Selection
Keys
Stitch Length
Lever
Stitch Width
Lever
Sewing Speed
Controller
Needle
Position
Button
Reverse
Stitch
Button
Start/Stop
Button
Presser Foot
Lever