Advertisement
5
[Reference for Assembling]
[Assembly Procedure of the Cap Section (Procedure for Production)]
Apply
grease
to the collar
Fit the stopper into the cap.
then place it in the cap.
Grease
(GEM1013)
Assembled state
[Wiring and Solder Positions of the Jack Board Assy]
Blue wire of the cord
from Speaker Assy L
Copper-colored wire of the
cord from Speaker Assy L
Solder each wire so that the end of each wire to be embedded in solder
faces inward and that the wires are laid inward, as shown in the photo.
5
6
Apply
grease
to the entire
inner circumference of the
wall of the hole at the center
of the stopper.
Attach the shaft to the hole of the
stopper. While holding the shaft
down with one finger, attach the
cap cover to the cap.
Jack
Cord from Speaker
Assy L
HDJ-1500-K
6
7
Apply
grease
to the
parts of the cap cover
indicated in the photo
above.
Attach the Cap Assy to
the inner slider.
Pass the cord through the shaft,
with the cord bent into an L
shape.
Red wire of the cord from
the headband
Copper-colored wire of the cord from
the headband
Cord from the headband
7
8
A
B
C
Slightly bend the end
of the cord.
D
E
F
5
8
Advertisement
