Table of Contents
Advertisement
Using the AUI Connectors
1. Slide the AUI retainer (included)
onto the connector posts on a
transceiver or an AUI cable.
2. Plug the transceiver or AUI cable
into the AUI port on the bridge and
secure it with the retainer's screws.
Tighten the screws until they are snug;
do not overtighten them.
3. Attach the network cable to the
transceiver.
Note
The Signal Quality Error (SQE) Test signal can be either enabled or disabled on
a transceiver attached to the bridge. The bridge ignores SQE Test signals.
2-6 Installation
AUI retainer
transceiver
or AUI cable
AUI port on
bridge
connector post
Advertisement
Table of Contents
