Table of Contents
Advertisement
2
Select/confirm desire function using the control
dial.
Selected guidance window appears.
Functions of function keys
: Displays the previous window.
F2
: Displays the next window.
F3
Functions of function keys
F2
: Displays the previous window.
: Displays the next window.
F3
3
Change the parameter.
Operate the process 2 and 3 of "6.2 Setting a basic parameter".
6.4 Setting an extended parameter (f---)
1
Select/confirm "Extended parameters" using
the control dial. When used with a VF-MB1
inverter, Select/confirm "Extended parameters
(f---)"
The Extended Parameters window appears.
Functions of function keys
: Displays parameters in the number range of
F1
900.
The number displayed decrements each time
this key is pressed.
: Displays the previous window.
F2
: Displays the next window.
F3
: Displays parameters in the number range of
F4
200.
The number displayed increments each time
this key is pressed.
2
Change the parameter setting.
To do this, perform steps 2 and 3 in the "6.2 Setting a basic parameter" section.
6. Operation in Parameter Setup Mode
0: No function
1: No function
2: Preset speed
3: Analog signal operation
CMOd
FMOd
ACC
dEC
FH
F100 : Low-speed signal freq
F101 : Speed reach frequency
F102 : Speed reach freq band
F105 : Priority of FWD/REV
F106 : Input terminal priority
F9--
F1
6-4
Basic Parameters
AUF
F2
F3
Guidance function
Preset speed
: Command input mode
: Frequency input mode 1
: Acceleration time 1
: Deceleration time 1
: Maximum frequency
F2
F3
Parameter Setup Mode
Extended Parameters
F2--
F2
F3
F4
G
口
Advertisement
Table of Contents
