Page 1
KitchenAid, VALUE DISPOSERS MODELS KWC=200B, KD-200 KD-100 INSTALLATION INSTRUCTIONS INSTALLER: FINAL GE.RlcL emove unit from carton and check for shipping 2. Sink flange assembled in center 3. Disposer level - not installed at an angle. 4. If a dishwasher drain...
Page 2
1. Use a small cold chisel or punch to cut out the back wall knockout washer inlet boss of the disposer. 2. Turn the disposer upside down to remove any pieces or chips from the grinding chamber. 3. KD-100, KD-200. & KWC-2OOB MODELS 3/4”...
Page 3
DISPOSER INSTALLATION 1. Be sure the isolating splash guard (8) is in place. Lift disposer and engage hooh (7) onto support plate (4), then engage hook (11) onto support plate (4). Turn disposer to align with drain trap. Snap lever (10) downward 2.
Page 4
COI~~~C~~~IS ment-Frounding terminal or lead on Lile appliance. KITCHENAID DIVISION \HOBART/ FORM 14609A (1 l-83) J/7 7459 POWER SUPPLY AT THE FUSE/ ELECTRICAL CONNECTIONS. of l/2 HP. motor. (Switch not from the control switch to the disposer below).