Toro Groundsmaster 300 Series Service Manual page 71
Hide thumbs
Also See for Groundsmaster 300 Series:
- Operator's manual (21 pages) ,
- Setup instructions (8 pages) ,
- Installation instructions (2 pages)
Table of Contents
Advertisement
Injection Pump Disassembly (Fig. 47)
The injection pump may be disassembled to replace
worn, damaged or defective components according to
the following procedures:
IMPORTANT: Clean external engine area near injec-
tion pump before disassembly. Do not spray water
on a hot injection pump. Do not remove Inter-cylin-
der adjusting plates unless necessary. If necessary,
scribe plates and housing carefully to ensure exact
repositioning upon reinstallation. Do not mix deliv-
ery valves, delivery valve seats, plungers or plunger
barrels from one cylinder to another. Handle these
parts carefully. Place these parts in clean diesel fuel
to prevent rust.
1. Remove the fuel pipes from the injection pump to the
injector nozzles.
2. Remove the fuel return hose by disconnecting the
collar from the pump, or by removing the hose clamp.
3. Remove the tie rod cover. Disconnect the Tie Rod
retaining spring and Tie Rod from the Control Rack.
4. Remove the four injection pump mounting bolts.
5. Remove the injection pump from the cylinder block.
Make note of the number and thickness of the adjusting
shims under the pump. The shims determine the injec-
tion timing.
6. Straighten the locking tabs on the plate which retains
the Tappet Guide Pin). Rotate the pin 180", push in on
the Tappet slightly and remove the Guide Pin and Tap-
pet.
7. Remove the Lower Seat, Plunger Spring, Upper Seat,
Control Pinion and Plunger.
8. Remove the Delivery Valve Holder, Gasket, 0-ring,
Valve Spring and Delivery Valve. Push the barrel as-
sembly out from below.
9. Remove the components of the other two injector
pumps using the same procedure.
10. To remove the Control Rod, remove the E-rings,
Ungleich set spring, and Ungleich set plate. Slide the
rack from the pump body.
11. To remove the smoke set plate, remove the cotter
pin, washer and return spring.
®
Groundsmaster
300 Series
1. E-ring
2. Ungleich set spring
3. Ungleich set plate
4. Pump housing
5. E-ring
6. Return spring
7. Smoke set plate
8. Air breather screw
9. Washer
10. Hollow screw
11. Pump element ass'y
12. Delivery valve ass'y
13. Gasket
14. Delivery valve spring
Page 4 - 41
Figure 47
15. O-ring
16. Delivery valve holder
17. Bolt/washer
18. Adjusting plate
19. Tappet guide pin
20. Plate
21. Control rack
22. Plunger control sleeve
23. Upper spring seat
24. Pump plunger spring
25. Lower spring seat
26. Shim plate
27. Tappet
Fuel System Service
- Quick Links:
- Service Manual
- Specifications
- Hydraulic Oil
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
