Table of Contents
Advertisement
I Test run
1. Be sure to set the electrolysis condition. (Refer to the Instruction Manual.)
2. Fill the water tank all the way with tap water.
G
Be sure to use normal tap (drinking) water.
Never use water from a water purifier, water from a water heater, alkali ion water, mineral water, well water,
seawater, or similar types of water.
These types of water cannot be electrolyzed and can cause the growth of mold or bacteria, resulting in odor.
G
The electrolysis condition setting must be set correctly according to the water quality in the region
where the product is used.
For details, refer to Section 2. USING THIS SYSTEM of the Instruction Manual.
G
Verify that the electrolysis condition setting switch is in the correct position.
3. Tighten the cap. At this time, check that no water spills
from the water tank.
4. Place the water tank in the designated position
in the unit.
5. Insert the tank gently.
6. Press the control panel ON/OFF button.
7. Verify that this product begins operating correctly.
At this time, verify that there is no abnormal noise
from the unit, and that there is no vibrating noise.
Unit built-in control section
CHILD LOCK lamp
DRAIN/DRY lamp
DRAIN/DRY button
Unit front display
FILTER lamp (red)
CHECK lamp (red)
7
8. LED indications
The meaning of the LED indications on the unit front display are as shown below. Take appropriate steps
according to the system status.
: ON
: Blinking (1 second ON, 1 second OFF)
Operation status
Stopped
Operating
Alarm
Filter indicator
Add water request
Drain request
Freeze prevention activated
Warming up
Drainage control in progress
Child lock engaged
9. Because the automatic cleaning operation function keeps the inside of the system clean when the system is
stopped, do not unplug the power cord after the test run, and verify that there is sufficient water in the water tank.
* After installation, if the system will not be used for a long period of time, drain the water from the water tank and
electrolyzed water tray, and fully dry the Virus Washer element.
(For details, refer to the Instruction Manual.)
CHILD LOCK button
LOUVER button
Operating mode
FILTER RESET
Indicates the fan speed.
button
ADD WATER lamp (red)
DRAIN lamp (red)
CHECK
FILTER
LED
LED
G
G
G
G
G
G
G
G
G
G
G
G
G
G
G
G
G
G
Test Run
Fill with water
to this point.
ON/OFF button
FAN SPEED button
Press this button to
change the fan speed.
OPERATION lamp (green)
HUMIDITY SAVER lamp (green)
2: Blinking (2 seconds ON, 1 second OFF)
Control section
DRAIN
ADD WATER HUMIDITY SAVER OPERATION CHILD LOCK DRAIN/DRY
LED
LED
LED
G
G
G
G
G
G
G
G
G
G
G
G
G
G
G
G
G
G
7 - 5
Cap
Water tank
Control section
panel
G: OFF
LED
LED
G
G
G
G
G
G
G
G
G
G
G
G
G
G
G
G
2
G
G
G
G
G
Installation
Water tank
panel
Display
LED
G
G
G
G
G
G
G
G
G
- Quick Links:
- Technical Data
Hide quick links:
Advertisement
Chapters
Table of Contents
