Page 1
OBJ_DOKU-10161-001.fm Page 1 Wednesday, November 14, 2007 8:14 AM Robert Bosch GmbH Power Tools Division 70745 Leinfelden-Echterdingen www.bosch-pt.com 12-2 | 14.4-2 1 609 929 M88 (2007.11) O / 14 en Original instructions...
1 Keyless chuck actually doing the job. This may significantly re- duce the exposure level over the total working pe- 2 Front sleeve riod. 3 Rear sleeve Bosch Power Tools 1 609 929 M88 | (14.11.07)
A significantly reduced working period after charging indicates that the battery is used and must be replaced. Observe the notes for disposal. 22.10.2007, Robert Bosch GmbH, Power Tools Division D-70745 Leinfelden-Echterdingen 1 609 929 M88 | (14.11.07) Bosch Power Tools...
Inserting the Battery Clamp the short end of an Allen key 13 into the keyless chuck 1. Use only original Bosch O-pack batteries with the voltage given on the type plate of Place the machine on a stable surface (e.g. a your machine.
For drilling in metal, use only perfectly sharp- Low speed range; for screwdriving or working ened HSS drill bits (HSS=high-speed steel). The with large drilling diameter. appropriate quality is guaranteed by the Bosch Gear II: accessories program. High speed range; for working with small drilling Before screwing larger, longer screws into hard diameter.
Fax: +353 (01) 4 66 68 88 tentional actuation of the On/Off switch can Australia, New Zealand and Pacific Islands lead to injuries. Robert Bosch Australia Pty. Ltd. For safe and proper working, always keep Power Tools the machine and ventilation slots clean.
Page 12
Defective or dead out battery packs/batteries must be recycled according the guideline 91/157/EEC. Batteries no longer suitable for use can be directly returned at: Great Britain Robert Bosch Ltd. (B.S.C.) P.O. Box 98 Broadwater Park North Orbital Road Denham Uxbridge UB 9 5HJ Tel.