Table of Contents
Advertisement
Installation & User's Manual
INSTALLATION AND SET UP
1. Power Requirements
The Vision.net Touchscreen operates on 27VDC. It is powered through the Touchscreen Control PCB (pre- installed
on the back of the touchscreen) via an external AC to DC power supply.
2. Mounting / Installation
Note: The Vision.net Touchscreen Control PCB is a card that connects to the touchscreen to allow VN/485 and RS-
232 communications. This card is mandatory for a Vision.net system that is communicating SVN/485 only. The
Touchscreen Control PCB is pre-installed in on the back of the touchscreen.
To install wall-mounted touchsreens:
Step 1. If conduit is required by local code, provide conduit to the back box where the Touchscreen Control PCB is
installed.
Step 2. Install the back box at the desired location.
Step 3. Refer to next section for touchscreen wiring and connections.
3. Wiring and Connections
Connecting Power - Using an External Power Supply
To connect an external power supply (not powering from Vision.net network):
WARNING! Make sure power is disconnected (removed) before connecting power to touchscreen.
Step 1. As shown in Figure 3, at Touchscreen Control PCB make sure jumper at JP1 is on Pins 1 and 2.
Touchscreen Control PCB
(located on back of touchscreen)
Detail A
Jumper
(across Pin 1 and 2)
Step 2. Using two (2), #14 AWG (.75 mm2) wires, connect external power supply as illustrated in Figure 3.
6
INSTALLATION AND SET UP
Wiring to
Touchscreen
(factory wired)
Figure 3: Touchscreen Control PCB Jumper Setting and Power Connections
Vision.net LAN
Jumper JP1
(see Detail A)
Vision.net Touchscreens
Power Input
(see Detail B)
Detail B
From External
Power Supply
Black (Common)
Red (+24VDC)
Hide quick links:
Advertisement
Table of Contents
