Using Telnet To Connect To The Nokia Ip40 - Nokia IP40 User Manual
Hide thumbs
Also See for IP40:
- User manual (244 pages) ,
- Quick start manual (4 pages) ,
- Quick start manual (4 pages)
Table of Contents
Advertisement
Click OK to continue.
5. The login prompt is displayed by default.
The IP40 ships without a password defined. If you are logging in for the first time, you will
be prompted to define the password by entering it twice. If you have logged in before, enter
the username and password you previously defined.
Refer to CLI Reference Guide for information on CLI commands.
Using Telnet to Connect to the Nokia IP40
You can access the Command Line Interface of your IP40 through a Telnet session.
Note
Telnet access is enabled only from the LAN side. You can allow Telnet access from the WAN
side by configuring separate user rules.
To connect to your IP40 using Telnet
1. Click Start > Run
2. In the command strip that appears, type telnet followed by your device's IP address
Nokia IP40 User Guide
Configuration Methods
51
Advertisement
Table of Contents
