Table of Contents
Advertisement
When the charging racks are wall-mounted the chargers should be connected as
follows:
Connect the power supply (maximum output 5A) as indicated in the following picture,
when charging racks should be coupled follow the instructions in this picture to
connect the cabling correctly. When the charging rack cabling is connected plug the
AC adapter plug into the 230V mains outlet.
3.5.
Battery Management
3.5.1. Battery Installation / Removal
The handsets are equipped with a rechargeable NiMh battery pack. The battery pack
is installed in the back of the handset housing.
The batteries can be charged and discharged hundreds of times, but sooner or later
they will be worn out. If the operating time is significantly shorter than usual, then it is
time to have the batteries replaced.
The batteries should not be removed by the user. This should be carried out by
qualified service personnel only.
When a user attempts to perform this action by him/herself no guarantee can be given
about the proper functioning of the handset anymore.
Do not shortcircuit the battery, the contacts or the handset.
3.5.2. Charge before Use
The handset is delivered with an almost uncharged battery. The handset has to be
placed in a charger or a charging rack and charged for at least 24 hours before use.
When the handset is placed in a charger or charging rack it switches on and the
display shows the battery status.
10
Advertisement
Table of Contents
