Yamaha A3000 Quick Manual page 20

Professional sampler

Hide thumbs Also See for A3000:

Table of Contents

Fig. Controller Events as CUBASE Arrangement

The Controller Templates can best be used if the Controller Matrix is set to an XG

compatible -/+ offset range of +63. In some cases, you will need to increase or decrease the

CUTOFF frequency of the Sample.

In the above illustration you can see the value ranges of the controller events (#074 = Cutoff)

which are traversed during the 8 bar parts. For example, the part "00–30" contains a

sequence of controller events (#074) of the value range 00 to 30 with all intermediate steps.

If you are not working with CUBASE or LOGIC, and load or important the

Templates as MIDI files into your sequencer program, the illustration will

be helpful only as an overview, since in this case the tracks will not

divided into parts.

The "TestSQ" in the last track can be used to test the Controller Templates. For this test

please load the "XMPMulti" (also included on the QUICK DISK) into the A3000.

The effectiveness of the Controller Templates will depend on the CUTOFF setting for the

corresponding Sample Bank, which should be modified if necessary.

The controller parts overlap, since the first controller event must be placed slightly ahead

of the actual bar range (see above). The first event of the Template "30–60" is already

located in the last quarter of the 8th bar, even though this Template is intended to control

notes in the area from bar 9 to 16.

Owner's Manual p. 208 – 217

A3000 Guide

Table of Contents

Show Quick Links

Table of Contents