Table of Contents
Advertisement
LTC 8555/00
Allegiant Keyboard
• Full-function, ergonomically-designed keyboard
• Variable speed joystick control
• 48-character on-screen display
The LTC 8555/00 Allegiant Keyboard is used with the
LTC 8200 Allegiant Video Switcher. It provides a conve-
nient means of operating and configuring the switcher.
It is equipped with a variable-speed pan and tilt joystick
control for positioning cameras, and also has an attrac-
tive screen for displaying camera information. The
Allegiant Keyboard and Allegiant Video Switcher are
used with the DCN Automatic Camera Control soft-
ware. A range of Allegiant Keyboard accessories is avail-
able, including a keyboard extension cable, keyboard
extension kit and keyboard rack mount kit. Refer to the
Bosch CSS Security Surveillance Data Book for more
information about keyboards and accessories.
Direct Camera Control
The DCN can also be used in the Direct Camera
Control (DCC) mode. A single AutoDome system is
then directly connected to a CCU for automatic camera
control. The video output of the AutoDome system is
connected to a monitor or other video display device.
The DCC mode is available both for DCN stand-alone
systems without a control PC and for DCN systems
with control PC. Setting of AutoDome system preposi-
tions in DCN systems with DCC requires use of Virtual
Keyboard software, both for DCN stand-alone systems
and PC-controlled DCN systems.
LTC 5138/00
Virtual Keyboard Software
This software provides the same functionality as a hard-
ware keyboard to configure and control a Bosch
AutoDome system. It is required in DCN systems with
Direct Camera Control to set the prepositions of an
AutoDome system. The AutoDome is temporarily con-
nected for this purpose to the installation PC or control
PC with installed virtual keyboard software for setting
the prepositions as required for the different DCN
microphone units. After this setting the AutoDome sys-
tem is connected to the DCN CCU. The virtual key-
board software is also needed to change the
programmed prepositions when required.
DCN Data Brochure
| Cameras and Accessories | 87
Technical Data
Dimensions (W x D x H)
220 x 51 x 155 mm
(8.7 x 2 x 6.11 in)
Weight
0.55 kg (1.2 lb)
The DCC mode can only be used in combination with:
• A Bosch AutoDome system
• CCU LBB 3500/05 with software version 9.30 or higher for
DCN stand-alone systems CCU LBB 3500/15 or
LBB 3500/35 with software version 9.30 or higher for DCN
PC-controlled systems
• Automatic Camera Control software LBB 3562/00 for DCN
stand-alone systems, version 2.00 or higher
• Automatic Camera Control software LBB 3588/00 software
for DCN PC-controlled systems
Hide quick links:
Advertisement
Table of Contents
