Table of Contents
Advertisement
Custom Master STB Setup (Cont.)
Custom Master STB Setup Procedure
1. Turn ON the STB/display panel.
The next step depends on whether the EZ-Manager Wizard appears on
the screen when you turn ON the STB/display:
• If the wizard is displayed, the STB is in the required factory default
state. Exit the wizard, and then continue with step 2.
• If the wizard is not displayed, restore the STB to a factory default
condition before continuing with this procedure. See Reference section,
"Restoring Factory Defaults on the STB(s)," as necessary, for further
information.
2. Set Installer Menu items.
This step provides specific instruction only on the Installer Menu items
that should be set on a Master STB. Refer to pages 25 to 34 for detailed
information on all Installer Menu items.
a) Use the Installer Remote to access the PTC Installer Menu (see
"Accessing the Installer Menu" on page 25 for further information).
b) Set Installer Menu item 003 BAND/AFC, as appropriate.
• Broadcast: Set to 0.
• CATV: Set to 1 (default).
c) Set any other Installer Menu items that affect your TV programming
network to the required configuration. For example, set the panel
display type (if applicable), enable/disable Aux inputs, set a Start
Channel, etc.
If you intend to use a TLX file for cloning purposes, you may also
configure selected settings in the IP Environment Menu (accessible
from the Installer Menu). See "IP Environment Setup" on pages 56 to
63 for further information. In particular, if you intend to use the Wi-Fi
Zoning feature, you must configure the wireless network connection
as part of the Master STB Setup. However, note that you cannot return
directly to the Installer Menu from the IP Environment Menu; thus, you
may wish to set all Installer Menu items as needed before you access
the IP Environment Menu. Otherwise, you will need to reaccess the
Installer Menu to set additional items.
d) After you have adjusted all Installer Menu item settings as required,
press OK once on the Installer Remote to save your changes; then,
press OK again to exit the menu.
36
• HRC: Set to 2.
• IRC: Set to 3.
STB_2000 PTC INSTALLER MENU
CPU-CTV
000 INSTALLER SEQ
000
UPN 000-000-000-000
ASIC D279
PTC V1.00.020
STB V3.08.00
Typical Installer Menu
003
BAND/AFC
001
Adjust the value for this
Installer Menu item, as required.
(Continued on next page)
206-4256
Advertisement
Table of Contents
