Table of Contents
Advertisement
ELETTRODOMESTICI
VIA CHECCHI 98
I 21013 GALLARATE
ITALY
Temperature regulation and heater cycles.
According to the temperature set point, the control drives the heaters to catch up with it. The cycles are defined for every cooking
mode as described in the next page table. Actually, the temperature regulation is based on the off time between two cycles. The
control can decide to run heaters cycle without any pause if the temperature is cool, or not to run any cycle if the oven is already at the
set-point and the insulation is good enough to prevent the oven from loosing heat. These two situations are the extreme ideal ones.
The additional element is used only in self-clean when the 208V power supply is selected, or during the preheat phase in Fast Preheat
modes.
Bake and Warming modes work with times divided by two when the set point is below 250°F
Tuesday, June 18, 2002
BOSCH 700 SERIES:
SERVICE INSTRUCTIONS FOR OVEN TESTING AND BASIC TROUBLESHOOTING
Page 27 of 28
Hide quick links:
Advertisement
Table of Contents
