Vertical Pole Mount; Ap 7161 Access Point Installation Guide - Motorola AP 7161 Installation Manual

Table of Contents

Vertical Pole Mount

Use the following procedures for vertical pole mount installations. Use of the extension arm is recommended when mounting the

access point to poles greater than 3 inches is diameter.

For poles up to 3 inches in diameter:

Thread the two inner nuts onto the U-bolt. Place the U-bolt at the desired mounting location.

Place the pole mount bracket section on the U bolt. Adjust the inner nuts until the pole mount bracket section is against the

pole and the U-bolt can be secured tightly to the pole.

Place the angle adapter bracket section on the U-bolt with the open slot connections on the bottom and align it with the pole

mount section.

Put the two outer nuts on the U-bolt to attach the angle adapter bracket section to the pole mount bracket section.

Tighten all nuts to 300 inch pounds (lbf-in).

Position the access point bracket section so that the bottom of the section with the straight (not bevel cut) sides is oriented

toward the bottom side of the AP with the gore vent. Using a torque wrench or a ratchet and a 10mm socket, attach (but don't

tighten) the access point bracket section to the AP 7161 with the with four M6 hex flange screws.

Insert two M6 hex flange screws into the bottom holes on the sides of the access point bracket section.

With the access point positioned so that the gore vent is facing down, insert the two M6 hex flange screws in the bottom holes

on the sides of the access point bracket section into the open slot connections on the bottom of the angle adapter bracket

section.

Rotate the access point bracket section upward and align the top holes on the sides with the top holes on the angle adapter

bracket section. Insert two M6 hex flange screws into the top holes on the angle adapter bracket section.

Use a torque wrench or a ratchet and a 10mm socket to finish attaching the access point bracket section to the angle adapter

10.

bracket section with the M6 hex flange screws in the open slot connections and the top holes on the angle adapter bracket

section. Do not tighten the screws until all rotation and tilt adjustments are complete.

Table of Contents

Show Quick Links

Table of Contents