Table of Contents
Advertisement
Chapter 4: Expanding or Modifying an Installed ITS
5. Click the ADD GROUP button. Repeat Steps 3 to 5 for each AP Group being
added on this system. When all AP Groups have been added, click the
NETWORK button to return to the View Groups tree screen.
For each AP Group that has been added, complete the follow steps:
Configure the
New AP Groups
1. In the View Groups tree, select an AP Group that was created and select the
BASIC SETTINGS tab.
In the 1.4 GHz AP Group Configuration Basic Settings screen, set the following
1.4 GHz AP
Configuration
configurations for this AP Group:
• Select the appropriate APC for this AP group from the Partnered AP
• Set the Default Group drop-down list to Smart-hopping.
• Set the WMTS Channels to match existing ITS configuration.
• Set the RF Access Code to match existing ITS configuration, and then set
• Mark the Use DHCP or Specify IP radio button as appropriate for your
In the 2.4 GHz AP Group Configuration Basic Settings screen, set the following
2.4 GHz AP
Configuration
configurations for this AP Group:
• Select the appropriate APC for this AP group from the Partnered AP
• Set the Default Group drop-down list to Smart-hopping.
• Set the Radio Regulations to match existing ITS configuration.
• Set the Frequency Plan to match existing ITS configuration.
• Set the ZigBee channel used for medical to match existing ITS
• Set the RF Access Code to match existing ITS configuration, and then set
• Mark the Use DHCP or Specify IP radio button as appropriate for your
2. Click SAVE and then verify that the AP Group Basic Configuration settings are
correct.
3. Select the ALERTS SETTINGS tab.
In the AP Group Configuration Alerts Settings screen, set the following
configurations for this AP Group:
• Alert Destination - Set as documented in the AP Group Configuration
• Sync Loss Alert - Verify all boxes are CHECKED.
4-16
Controller drop-down list. Refer to your completed AP Group Configuration
Worksheet.
the Enable Box to CHECKED.
network. When specifying the IP address, you must set the Subnet Mask
and Default Gateway fields to match the existing ITS configuration.
Controller drop-down list. Refer to your completed AP Group Configuration
Worksheet.
configuration.
the Enable Box to CHECKED.
network. When specifying the IP address, you must set the Subnet Mask
and Default Gateway fields to match the existing ITS configuration.
Worksheet.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
