Setting For The Lan To Connect The Multiple Units - Sony BVM-F250 Operation Manual
Professional video monitor
Hide thumbs
Also See for BVM-F250:
- Operation manual (146 pages) ,
- Manual (36 pages) ,
- Operation manual (140 pages)
Table of Contents
Advertisement
If 4 Asia Except Japan is selected:
Select Area
Asia Except Japan
NTSC Area
B
PAL Area
B
Customers who will use this monitor in the shaded
areas shown in the map below should select NTSC
Area.
Other customers should select PAL Area.
Then press the ENTER (Ent) button.
3
Confirm the settings.
Select Area
XXXXXXXXXX
Color Temp:
xx
Setup Level:
xx
Component Level:
xx
xx
Color Profile:
Cancel
Confirm
Cancel: Select to cancel the setting and return to the
Select Area screen.
Confirm: Select to save the setting and end selecting
the area.
See "Default value for each area" on page 34 on the
setting value.
After saving and reflecting the setting, you can change the
setting with the menu.
• Color Temp (color temperature) (page 58)
• Setup Level (NTSC Setup Level: page 61, Betacam
NTSC area
• Component Level (page 61)
• Color Profile (page 59)
PAL area
Setting for the LAN to Connect the
Multiple Units
You can control the multiple monitors using the controller
(BKM-16R, optional) connected via each LAN (10/100)
connector. You can also control a specific monitor or
monitor group.
Set an IP address to the monitors and the controller and a
monitor ID number and group ID number to each monitor.
1
Setup Level: page 61)
Set the NETWORK switches of each monitor and the
controller to PEER TO PEER.
BVM-F250
NETWORK switch
t Set to PEER TO
PEER.
Controller
(BKM-16R)
NETWORK switch
tSet to PEER TO PEER.
35
Settings
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
