Miele SEB213-2 Operating Instructions Manual page 21

Powerbrushes

Hide thumbs Also See for SEB213-2:

Table of Contents

Available languages

Replacing the roller brush drive belt

The Powerbrush housing must be

opened in order to replace the drive

belt.

^ Remove the roller cover a by

loosening the two lock screws on the

bottom of the Powerbrush using a

coin or screwdriver. Remove the roller

cover.

^ Pull up the roller brush b until it

releases from the main housing, and

slide the drive belt over the end of

the brush. Set the roller brush aside.

^ Remove the 4 screws c in the lower

housing of the Powerbrush d, then

separate the lower housing from the

upper housing e.

^ Install a new drive belt by slipping it

over the gear on the motor shaft and

the toothed side of the roller brush.

^ Reassemble the Powerbrush by

reversing the procedure.

Maintenance and Care

Table of Contents

Show Quick Links

Table of Contents

Seb 217 Seb213