Table of Contents
Advertisement
Ethernet connection
The standard RJ-45 Ethernet socket is used to connect the unit directly to a PC
or to a network. To connect directly to a network hub, use a straight-through
network cable. To connect directly to a PC, use the supplied cross-over network
cable. Consult with your local IT personnel for the specific type of cable needed.
The cable length from node to node is limited to 100 feet (30.5 meters)
maximum length and 6 feet (1.8 meters) minimum length.
Network configuration
The Divar is delivered with the DHCP function switched on, so IP addresses are
assigned automatically if the network server uses DHCP. (Refer to the
settings/Connectivity/Network setup menu.)
Specifications
Connection:
10/100 BaseT, IEEE 802.3
Differential signal voltage:
± 2.8V max, inputs have transient overvoltage protection.
Port details:
IEEE 802.3/802.3u - 100Base-TX/10Base-T physical layer.
Auto Negotiation: 10/100, Full / Half Duplex
Cable length:
100 Meters: 100 Ohm unshielded twisted pair cable,
category 3/4/5.
100 Meters: 150 Ohm shielded twisted pair cable.
Impedance:
In-built compensation for impedance matching.
Indicators:
ACT, 10, 100
Philips Communication, Security & Imaging
LAN - RJ-45 Ethernet socket
Signal Name:
Pin no.
LAN_TX+
1
LAN_TX-
2
LAN_RX+
3
N/C
4
N/C
5
LAN_RX-
6
N/C
7
N/C
8
System
Description
Ethernet transmit line plus
Ethernet transmit line minus
Ethernet Receive line plus
No Connection
No Connection
Ethernet receive line minus
No Connection
No Connection
8
1
Hardware setup
Panel view
4-5
Advertisement
Table of Contents
