HP 200 Series Services And Applications page 215
Hide thumbs
Also See for 200 Series:
- Installation manual (144 pages) ,
- Hardware support document (95 pages) ,
- Instructions manual (7 pages)
Table of Contents
Advertisement
TA
a
Events
DTR
CTS
data
rec'd
CRN
VAL
CTS
call TA "B"
DSR
*** Connection Established ***
Data Transmitted
Figure 10. Connection Sequence for V.25 bis
Figure 10 shows the sequence of events in a successfully initiated
connection between routers using V.25 bis terminal adapters. To signal that it
is ready to engage in a V.25 bis dialog, the adapter raises its CTS lead (clear
to send). The "CRN" sent by the router to the adapter is a connection request
and the phone number to dial. The adapter responds with "VAL", which
simply indicates that the request was formatted properly and that the
adapter was in the proper state to receive the request. The adapter lowers
CTS when an answer tone is detected to disable further V.25 bis dialog. The
call is then placed.
On the receiving side, the adapter that previously raised CTS sends the
router an "INC" to indicate that an incoming call has arrived. The originating
phone number and the first part of the data packet is forwarded to the
router; this assumes that ANI (automatic number identification) is available.
Thus, the "ring indicator" control signal is not required for detection of an
incoming call since that is obtained using the V.25 bis "INC" indication. If the
Improving Network Availability
Switched Circuit Types
ISDN
TA
Network
DTR
CTS
call from "A"
rec'd
INC
CTS
DSR
b
3-21
Advertisement
Table of Contents
