Hitachi P 20DA Technical Data And Service Manual page 13

Cordless planer

Hide thumbs Also See for P 20DA:

Table of Contents

8-1-2. Removal of Pulley (A) [28] and Pulley (B) [15] (See Fig. 9.)

(a) Remove the one Tapping Screw D4 x 25 [16] which fixes Belt Cover (B) [26] to the End Bracket [29], then

remove Belt Cover (B) [26].

(b) Pulley (A) [28] (left-hand threaded) and Pulley (B) [15] (right-hand threaded) are screwed onto the motor

shaft and the cutter spindle respectively. To remove Pulley (A) [28], fit a wrench to Pulley (A) [28] and put

the blade of a flatblade screwdriver into the groove at the tip of the motor shaft, then turn the screwdriver

counterclockwise.

[15], then turn the wrench counterclockwise. It is recommended to wrap the Cutter Block Ass'y with a thick

cloth to prevent injury to fingers.

8-1-3. Removal of the Cutter Block Ass'y [18] and the Motor with Fan [32] from the End Bracket [29] (See Fig. 10.)

(a) After removal of Pulley (B) [15], tap the end of the spindle of the Cutter Block Ass'y [18] with a wooden

hammer. Then the Cutter Block Ass'y [18] can be removed.

(b) After removal of Pulley (A) [28], tap the end of the motor shaft slightly with a wooden hammer. Then the

Motor with Fan [32] can be removed.

Tap the end of the

motor shaft slightly

with a wooden hammer.

Tap the end of the

spindle with a

wooden hammer.

Fig. 9

Fig. 10

--- 11 ---

Table of Contents

Show Quick Links

Table of Contents