2 electrolux The control panel Lid button Filter access cover Adjustable levelling feet CONTROL PANEL 1. Programme selector 2. Pushbuttons and their functions 3. Display 4. "Add washing" light 5. "Start/Pause" pushbutton 6. "Time manager" pushbuttons THE SYMBOLS Time manager...
3 DISPENSER BOX Prewash Wash Softener (do not fill above the MAX symbol SAFETY INFORMATION Please read these points carefully before in- • Ensure that, after installation, the power stalling and using your appliance. Keep this cable is not trapped under the appliance.
4 electrolux mation which would damage your appli- with petrol, alcohol, trichlorethylen etc. If ance. such stain removers have been used, Before turning your appliance on again, en- wait until the product has evaporated be- sure that it is installed in an area where the fore putting these items into the drum.
Page 5
5 PROPORTIONING OF DETERGENTS lected programme, “Err” flashes on the dis- play and the “Start/Pause” pushbutton Pour the amount of washing into the wash- flashes red. and prewash compartments if you have selected the “prewash” option. “PREWASH” OPTION Pour fabric softener into the compartment if necessary.
Page 6
6 electrolux TIME MANAGER INTERRUPTING A PROGRAMME The cycle can be made longer or shorter by Adding washing using the “Time Manager” pushbuttons. When the “Add washing” light is on, you The level of soiling of the laundry is also in- can add washing by proceeding as follows.
7 PROGRAMMES TABLE Programme / Type of washing Load Possible options 5,5 kg Night silence plus, Prewash, Rinse Cottons (cold - 90°) : White or colour, plus, Time manager, Delay start e.g. normally soiled work clothes, bed linen, table linen, body linen, towels.
9 OPERATING PROBLEMS Numerous checks were carried out on your refer to the sections below before contact- appliance before it left the factory. Howev- ing the after-sales service. er, should you notice a malfunction, please Problems Causes The washing machine •...
10 electrolux Problems Causes The wash cycle is much • the water inlet filters are dirty, too long : • the power or water supply has been cut off, • the motor overheating detector has been activated, • the water inlet temperature is lower than usual, •...
11 TECHNICAL SPECIFICATIONS DIMENSIONS Height 850 mm Width 400 mm Depth 600 mm LINE VOLTAGE /FREQUENCY 230 V / 50 Hz POWER CONSUMPTION 2300 W WATER PRESSURE Minimum 0,05 MPa (0,5 bar) Maximum 0,8 MPa (8 bar) Connection to water supply...
12 electrolux DRAINAGE lead or multi-plug adaptor. Ensure that the plug is earthed and that it is in accordance Fit the U-piece on with current regulations. the drainage hose. Place everything in a POSITIONING drainage point (or in Position the appliance on a flat and hard...